Look Solutions ORKA Fog Machine w/ DMX

ORKA power-fog generator is the most powerful fog generator available on the market that is produced as a serial product. It can be used wherever a high quantity of fog is needed in a very short time. Due to its enormous power and the strong output very large halls and even stadiums can be filled with fog.

The ORKA is the perfect machine for Events, Concerts, Special effects, Theme parks, large TV- and Film-Studios and for Fire brigades or Disaster control examinations. The compact dimensions and the robust housing the machine make it suitable for touring use. The ORKA can be controlled via DMX 512. The connection is done with 5pin-XLR-plugs. The DMX start address can be adjusted and saved via the control panel. If an external fan is connected to the machine it can be controlled separately via DMX as well and can be used as a wind machine.

The machine can also be controlled with analog (0 - 10 V) via a lighting desk or via XLR-remote (option). This connection is done with 3pin-XLR-plugs. A stand-alone-mode is also possible. The adjustments are done directly at the machine. A short press at the start button makes the machine run. Therefore a permanent pressing of the start button is unnecessary. With the internal timer the fog time can be exactly adjusted in seconds, the wait time in minutes and the output in Control panel - The control panel with LED-display, simple symbols allow for easy operation. It also protects the control buttons against dirt.

Finest adjustments of the output - Digital technology makes fine adjustment of the pump possible. In steps of 1% the output can be adjusted from 0 - 99%. Thus, any desired effect from a tiny fog-cloud to the thickest fog can be produced. This enables the Orka to be used in both small and large locations.

Connector for external fan - An external fan with max. 800 Watt can be connected to the ORKA. Once connected to the machine, the fan can also be adjusted via DMX. The machine then uses two following channels at the desk.

Procedure - vaporizing fog machine
Power requirement - 9000 Watt / 8000 Watt (208 V)
Voltage - 3 x 230 V with neutral, 50 Hz - 1 x 208 V, 60 Hz, 40 A (USA)
Warm up time - approx. 15 min.
Fluid consumption at 100% output - 500 ml/min.
Fog output - adjustable in 99 steps
Output projection - max. 30 m
Fogging time - at 100% output - at < 50% output - approx. 2 min - continuous output
external Fan - max. 800 Watt - integrated capacitor
Air quantity - adjustable in 99 steps
Control DMX 512 - 0 - 10 V analog - Stand-alone-Mode - Radio remote (Option)
Temperature control Microprocessor two thermocouples Overheating protection - Heater block/thermostat - Pump/Thermal switch
Dimensions (L x W x H) 55 x 37 x 28 cm Weight 30 kg - 70LBS

(please note this fog machine need special 220v power requirements)